Choose the Right Industrial Chiller

Update:11 Dec 2017
Summary:

It is often advantageous to install multiple installati […]

It is often advantageous to install multiple installations and divide by productivity. In this case, white shifts can be fully installed, but at night, on weekends and holidays, this is a rather small car. This saves operating system time and increases the reliability of the cooling system.

The main task is to choose the industrial chiller pump will affect the following factors: the distance from the industrial refrigerator to the consumer location, the diameter of the pipe, and the need to lift this very fluid at any height.

Unacceptable matching industrial refrigerators with powerful electric drive capacity exceeds the required level. Because some customers are buying "future" cooling equipment, hopefully over time they will need a lot of capacity. For example, a refrigerator that purchases very high cooling capacity, hopefully in the future will be additional equipment that requires water cooling. It seems this calculation is correct. By purchasing a more powerful industrial refrigerator today, it is certain that tomorrow it will have enough room for new equipment. However, there is a problem.

Industrial chiller often turn on / off if the thermal stresses on the refrigeration equipment are greater respectively. There are limits to the number of starts per hour for electrically powered powerful devices. At the same time, whenever the equipment is operating in the most unfavorable state: the starting current is more than 10 times the rated value, and accordingly, the heating cable can be up to 100 times higher than when operating at nominal conditions. Increasing the current at start-up results in higher torque, resulting in a dynamic effect on the clutch, bearing and shaft for each shot.

The best level of industrial chiller is achieved when work is done throughout the entire shift. This requires choosing a chiller unit that will barely cover the maximum heat flux. In addition to precisely selecting the productivity of the device, different ways to reduce the transmit frequency can also be considered.